Ferrari Enzo OpenRC F1 Mod

The Ferrari Enzo OpenRC mod is based on Daniel Norées OpenRC 3D Printable F1 model

 
 

DOWNLOAD Ferrari Enzo OpenRC mod NOW

Background movie full video at this link.
 

Woah! It’s been a while since I started this project. That’s for sure. Finally I’m done. The parts work, the car spins and the design is final!

The Ferrari Enzo OpenRC mod is of course based on Daniel Norées OpenRC F1 model that you can download via MyMiniFactory, at thingiverse or at Pinshape. Now, the new parts all need to be printed, but you still need some parts printed from the F1 design:

 
PartsNeeded_2-150x150.jpg

  • Tire_V2

  • Rear_rim

  • Servo_Holder

  • Servo_saver

  • Steering_push_pin

  • Wheel_Axle_holder_left

  • Wheel_Axle_holder_Right

  • Spur_Gear, Wheel_Lock_Nut

 
PartsNeeded_1-150x150.jpg

  • Servo_Save_Upper

  • Front_Lower_BOM

  • Front_BOM_block

  • Front_wheel_axel

  • Front_Upper_BOM

  • Pinion_Gear

  • Front_rim

  • Front_Wheel_Hub

  • Rear_wheel_Axle

 

Now, I do use more of the M3x12 counter sunk screws, so it’s good to stack up on those!

If you need a full kit of parts for the F1, check out this link to 3DprintnPack where you can buy everything.

Then there’s this Bearings kit that you can get as well.

However, if you don’t need everything, please use the links here since they’ll support me (wont cost you anything extra):

540 Sensored Brushed Motor Shaft 3.175mm For 1/10 RC Cars – 35T
 
Flysky FS-GT3C Transmitter Remote Control With Receiver Color Gray
QuicRun 1060 Brushed ESC 60A/360A 2A/5V 11.1V RC Car Part
 
ZOP Power 7.4V 2200mAh 2S 35C Lipo Battery T Plug
MG90S Metal Gear RC Micro Servo For RC Model
 
iMAX B6-AC B6AC Lipo NiMH 3S RC Battery Balance Charger
2019-04-05-17_22_34-original-skyrc-imax-b6-mini-60w-6a-balance-charger-discharger-with-power-supply--150x150.jpg
 

You might also need a few of these connectors.

Daniel Norée listed these items with more instructions if you need that! Find all of that here.

 
 
Previous

DSLR
Next

Community3DPrinter